Advanced Settings 23
Trap packet is the packet that Agent proactively sends to NMP to report some emergent and
important events, for example, the manged device roots.
By default, Agent is allowed to send SNMP Trap packet.
Select Advanced > Configuration > Security > SNMP > Trap. Step 1
The Trap interface is displayed. See Figure 4-26.
Trap Figure 4-26
Click Add New Entry in Trap Destination Configurations. Step 2
The SNMP Trap Configuration interface is displayed. See Figure 4-27.
SNMP Trap configuration Figure 4-27
Set the parameters. See Table 4-6. Step 3
Table 4-6 NMP Trap configuration parameter
Input the Trap Config name.
Select Enabled or Disabled to enable or disable the function.
Three versions: SNMP v1, SNMP v2c, and SNMP v3.
Input the Trap community name.
Input the Trap destination address.
Input the port number of the target host.
To Next Page
Loading...
