Advanced Settings 42
Static
Select Advanced > Configuration > Aggregation > Static. Step 1
The Statics interface is displayed. See Figure 4-59.
Static configuration (1) Figure 4-59
Select the Hash Code Contributors in Aggregation Mode Configuration. There are four Step 2
types:
Source MAC Address: the aggregation load balancing algorithm based on MAC
address.
Destination MAC Address: the aggregation load balancing algorithm based on
destination MAC address.
IP Address: the aggregation load balancing algorithm based on source IPv4
address and destination IPv4 address.
TCP/UDP Port Number: the aggregation load balancing algorithm based on
source and destination TCP/UDP port.
Add the port member to the aggregation group in Aggregation Group Configuration. For Step 3
example, add port 1 and port 2 to Static Group 1. See Figure 4-60.
Up to 13 static groups can be set at the same time.
To Next Page
Loading...
