Note:
The intrusion function is valid once your network camera or your DVR supports this
function.
If you want to use the IVS function of the network camera, please make sure your
connected network camera supports this function.
Step 1 From main menu->Setup->Event->IVS, click to add the rule. Select rule
type as intrusion.
Note
Double click to change a rule name.
Step 2 Check the box to enable Intrusion function. See Figure 5- 80.
Figure 5- 80
Step 3 Click Draw rule button and then left click mouse to draw an intrusion rule. Right
click mouse to complete. See Figure 5- 81.
To Next Page
Loading...
