Dahua XVR4108C-S2 User Manual

599
e) System only checks start address if you add IP address. System check start
address and end address if you add IP section and the end address shall be
larger than the start address.
f) System may check newly added IP address exists or not. System does not add if
input IP address does not exist.

Delete: Click it to remove specified item.

Edit: Click it to edit start address and end address. See Figure 5- 149. System can
check the IP address validity after the edit operation and implement IPv6 optimization.

Default: Click it to restore default setup. In this case, the trusted sites and blocked
sites are both null.
Step 4 Click Save to complete setup.

If you enabled trusted sites, only the IP in the trusted sites list can access the
device.

If you enabled blocked sites, the IP in the blocked sites cannot access the
device.
Figure 5- 148
Figure 5- 149
5.11 Information
5.11.1 Version
Here you can view record channel, alarm input/output information, software version,
release date and etc.

Dahua XVR4108C-S2 Specifications

General

Brand	Dahua
Model	XVR4108C-S2
Category	DVR
Language	English