Daikin Altherma 3 H F - Operation

10 | Configuration
Installer reference guide
151
EPGA11~16DAV3(7) + EAVZ16S18+23DA6V(7)+9W
Daikin Altherma 3 H F
4P556075-1A – 2021.09
Disable protections
INFORMATION
Protective functions – "Installer-on-site mode". The software is equipped with
protective functions, such as room antifrost. The unit automatically runs these
functions when necessary.
During installation or service this behaviour is undesired. Therefore, the protective
functions can be disabled:
▪ At first power-on: The protective functions are disabled by default. After 12
hours they will be automatically enabled.
▪ Afterwards: An installer can manually disable the protective functions by setting
[9.G]: Disable protections=Yes. After his work is done, he can enable the
protective functions by setting [9.G]: Disable protections=No.
# Code Description
[9.G] N/A Disable protections:
▪ 0: No
▪ 1: Yes
Forced defrost
Forced defrost
Manually start a defrost operation.
# Code Description
[9.H] N/A Do you want to start a defrost operation?
▪ Back
▪ OK
NOTICE
Forced defrost start-up. You can only start forced defrost when the heating
operation has been running for a while.
Overview field settings
Almost all settings can be done using the menu structure. If for any reason it is
required to change a setting using the overview settings, then the overview
settings can be accessed in the field settings overview [9.I]. See "To modify an
overview setting"[489].
10.5.10 Operation
To enable or disable functionalities
In the operation menu, you can separately enable or disable functionalities of the
unit.
# Code Description
[C.1] N/A Room:
▪ 0: Off
▪ 1: On