Daikin DPSA - Features and Options


www.DaikinApplied.com 7 CAT 258 • REBEL APPLIED ROOFTOP


Standard Features
• Double-wall foam-injected panel with thermal resistance
of R-13
• Integral thermal break in all walls, doors, oors and roof
panels
• Low air leakage: <0.5% air leakage at +/- 5 in w.c. of
static pressure; CL6 @ 6 in w.c. per ASHRAE Std 111
• Pre-paint exterior surfaces withstand a minimum 1000 hr
salt spray test per ASTM B117
• Access doors are mounted with durable full length
stainless steel piano style hinge.
• A single, lockable handle and latch mechanism plus door
holders on each access door.
• Dual refrigeration circuits with fully interlaced evaporator
coils
• Minimum operating ambient down to 50°F mechanical
cooling
• A minimum of four stages of compressor capacity control
for stable discharge air temperature and humidity control
• A minimum of (2) direct-drive ECM supply fans to o󰀨er
redundancy, reduced maintenance, and higher e󰀩ciency
• 2" MERV 8 ltration with dirty lter monitoring
• Multi-stage gas heat with 439 stainless steel heat
exchanger
• Multi-staged electric heat
• Hot water or steam heat
• Standard 1 year parts, labor and compressor warranty
• Standard 10 year gas heat exchanger warranty
• Separated high and low voltage control panels for safe
access to human control interfaces
• 208V/230V/460V/575V
• Single point power block connection
• 10 KAIC SCCR
• Phase voltage monitor
• MicroTech
®
4 controls
Customizable Features
• 100% or 0–30% outisde air damper or 0-100%
economizer damper
• Low static exhaust or high static exhaust or return fans
• Energy e󰀩ciency (coil face area, 6 row coils)
• Modulating hot gas reheat for dehumidication
• Low ambient mechanical cooling
• Quiet condensing and compressor sound blankets
• Speedtrol
®
, modulating head pressure control
• Outdoor and Fan Airow Measuring
• Refrigerant system monitoring (liquid, suction, and
condensing refrigerant pressure/temperature sensors)
• Modulating gas heat control between 5:1 and 100:1
turndown
• Modulating hot water and steam control valves
• ECM supply fan array with backdraft dampers for
redundancy
• Extended 5 year parts, labor and compressor warranty
• Extended 20 year heat exchanger warranty
• 2"/4" lter rack with Merv 8 or 13 lters
• 2" Merv 8 pre-lter with 12" rigid cartridge Merv 11, 14,16,
or carbon lters
• Final lters – 12" rigid cartridge MERV 14, 16, HEPA
• Non-fused, unit mounted disconnect switch
• Dual point power for back-up power systems
• 115V service outlet
• 65 KAIC electrical rating
• Line reactor, power factor correction
• MicroTech 4 controls with BAS integration and power
measuring