Indoor Unit SiUS04-924
Removal Procedure 151
2
Remove the fixing screw
of the fan rotor.
3
Remove the fan motor. Reassembling the fan motor
When reassembling the fan
rotor, provide as much as
0.2inch (5mm) of play
between the side face of the
rotor and the bottom frame.
Insert the fan motor approx.
0.2inch (5mm)
Tighten the screw until it
stops. Then turn the screw by
one turn.
Move the fan rotor and
confirm the fan motor and the
fan rotor are installed
appropriately.
Tighten the screw completely
if appropriate.
If not appropriate, go back to
.
4
Remove the fan rotor.
Step
Procedure Points
(R9648)
To Next Page
Loading...
