Daikin FTXS30HVJU - Intelligent Eye

Main Functions SiUS04-924
Function and Control 21
1.9 INTELLIGENT EYE
This function detects movement in the room by a human motion sensor (INTELLIGENT EYE),
reducing capacity when the room is empty in order to save electricity.
Processing 1. Detection method by INTELLIGENT EYE
 This sensor detects motion by receiving infrared rays and displays the pulse wave output.
 A microcomputer in the indoor unit carries out a sampling every 20 msec. and if it detects 10
cycles of the wave in one second in total (corresponding to 20msec. 10 = 200msec.), it
determines there is movement in the room as the motion signal is ON.
2. The motions (for example: in cooling)
 When a microcomputer does not have a signal from the sensor in 20 minutes, it detects no
presence is in the room and operates the unit at a temperature shifted 3.6°F(2°C) from the set
temperature. (Cooling/Dry : 3.6°F(2°C) higher, Heating: 3.6°F(2°C) lower and Auto : according
to the operation mode at that time.)
1 In case of Fan mode, the fan speed reduces by 50 rpm.
If the sensor detects the outputs 10 times/sec.
or more, it judges humans are present.
1sec
sampling (20msec)
High
Low
ON
OFF
Sensor output
(Human motion)
Human detection
signal
(R2821)
ON
OFF
RESET.
Cooling : Set temp. + 3.6˚F(+ 2˚C)
Heating : Set temp. – 3.6˚F(– 2˚C)
Human detection
signal
20 min. 20 min.
within 20
minutes.
40 min.
MaxHz
MinHz
0Hz
Compressor
speed
The lower limit by detecting
human.
(Prohibition of thermostat-off)
ON
OFF
ON
OFF
Operation
OFF
Fan speed (1)
Set speed – 50 rpm
Set speed Set speed
in case of
thermostat-off
Frequency at set temp. +3.6˚F(+ 2˚C)
Set temp.
(R9861)
Remote controller
INTELLIGENT EYE
button