Operation Manual SiBE81-909
28 Humidifying Air Purifier
5.8 Air Purifying Operation
19
Air Purifying Operation
1
Press .
• If humidification was run the last time that the unit was used, humidification starts automatically,
therefore press to turn OFF the humidification lamp.
2
Press to change the airflow rate.
• Each time the button is pressed, the airflow rate changes as follows.
Airflow rate ((Quiet) (Low) (Standard) (High))
is automatically adjusted according to the dirty
state of the air.
This is the high airflow rate mode that
quickly removes airborne dust.
Air flows at a super slow rate.
This mode is recommended when sleeping.
The airflow rate is changed every 5
minutes to create gentle air currents
so as to catch the pollen before
settling on the floor.
• The default settings are air purifying operation and “auto” airflow rate control.
If the power supply cord is unplugged or if the front panel was opened and the unit restarted, the next time
that the unit is used, it runs at the last used settings.
Plug the power supply cord
into an electrical socket.
• Do not insert or remove the power plug to turn
the unit on/off.
Abusive handling may lead to electric shock or
fire because of overheating.
Socket
Power plug
NOTE
Humidification lamp
ON/OFF
HUM ON/OFF
FAN SET
(Automatic) (Quiet) (Low) (Standard) (High) (Turbo) (Pollen)
Auto mode
Turbo mode
Quiet mode
Anti-pollen mode
ATTENTION
To Next Page
Loading...
Need help?
General
