Operation Manual SiBE81-909
42 Humidifying Air Purifier
33
Care & Cleaning
Procedure
UNIT1
(1) Ionizing frame (2) Ionized wire
(3) Opposing pole plates
Remove parts.
Suck up dust on the front surface with a
vacuum cleaner.
T
Soak in lukewarm or plain water.
(Approx. 1 hour)
T
Remove dirt with a piece of cloth, soft
bristle brush, etc.
T
Rinse in running water and drain.
T
Dry in a well-ventilated shade. (Approx.
1 day)
T
Reattach parts.
(1) Ionizing frame (Remove dirt after soaking but before drying.)
• Remove dirt from plastic parts with a soft piece of cloth.
• Wipe away dirt in recesses and places where fingers do not fit with a cotton swab, etc.
• Do not leave any lint from cleaning cloths behind. Lint may lead to malfunction.
CAUTION
• Before performing maintenance, stop the unit and unplug the power
supply cord.
• Wear rubber gloves to when wiping or rubbing the units.
Hands can be cut on the opposing pole plates and ionized wires.
WASH UNIT1
If UNIT lamps light
UNIT2
Soak, drain and dry
XPage 32. XPage 32.
Vacuum cleaner
Soak in lukewarm/
plain water.
Remove dirt.
Wipe
Wear rubber
gloves.
(For details, see (1) and
(2) in the below figure.)
Rub
Wear rubber
gloves.
XPage 31. XPage 32.
Cotton swab
Wear rubber
gloves.
*Remove dirt from recesses
with a cotton swab, etc.
Cleaning UNIT1 (plasma ionizer) and UNIT2 (streamer unit)
Wear rubber gloves
when cleaning.
To Next Page
Loading...
Need help?
General
