The timer setting indicator lights depending •
on the remaining time.
The set time can be changed while the timer •
is running.
Humidify setting button
Each time pressing this button, the
humidify setting changes as follows.
Page 20.
The humidify setting cannot be changed when •
humidifying operation is OFF.
Fan setting button
Each time pressing this button, the airfl ow rate setting changes as
follows.
Page 19.
<Front indicator lamps>
“ • ” and “ ”, “ ”, “ ” or “ ” will be lit simultaneously while in auto
mode.
The fan will be set to auto mode if the HIGH, STD, or LOW humidify setting is •
selected while in humidifying operation.
ATTENTION
The operating panel is covered in a protective sheet to protect against scratching. ●
Peel the sheet off before use.
If the front panel is opened during operation, the unit stops for safety reasons. ●
If the unit malfunctions during operation
During operation, if the indicator lamps light erroneously or the unit cannot be
operated because of lightning or other reason, unplug the power supply cord, wait at
least 3 seconds, plug the power supply cord back in and start the unit.
Humidify ON/OFF button
Each time this button pressed, the •
humidifying operation is turned on
and off.
The lamp is lit while humidifying •
operation is ON.
Air purifying operation is in active •
while humidifying operation.
(Humidifying operation cannot run
by itself.)
ON/OFF button
When this button is pressed,
the unit starts. When pressed
again, it stops.
To Next Page
Loading...
