Electrical Installation
13
H-2103 Connection
H-2103 hockey scoring modules must connect to an H-2102 or H-2115. H-2103 modules
may be placed above, below, or beside other scoreboard sections and are equipped
with digit jacks on both the top and the bottom of the cabinet. Connect the two DIGIT
INPUT jacks (J11 and J12) to the matching DIGIT OUTPUT jacks (J11 and J12) using the
included 9-pin to 9-pin cables.
Shot Clock Power/Signal Connection
Reference Drawings:
Wiring for Shot Clock on Portable Backstop...................................................... DWG-98293
Block Diagram: AS5000 BB- VB and WR #3 ...................................................... DWG-124688
For wiring of permanent or portable shot clocks, refer to DWG-124688 in Appendix B.
For a typical installation of a shot clock mounted to a portable backstop structure, refer
to DWG-98293.
Some shot clock models include a power cord while others include a twist-lock plug for
connection to the shot clock’s power inlet; the cord itself must be sourced locally and
terminated between the shot clock and grounded receptacle.
Shot clocks may be controlled via radio rather than wired signal connection. Refer to
Wireless Signal Connection (p�11).
To Next Page
Loading...
