MANUALE INSTALLATORE RELEASE 00.1 PAG. 12
Push to highlight the set value, then use or to
change it, push again to confirm it and then to go back to
previous menu.
6-8 Water mixing for tea
This menu is used to enable and adjust water mixing with the two hot
water buttons.
The default settings are: S1=NO S2=NO
Push to access this menu.
Push to select S1, then again to decide whether to enable
the function or not, then again to select the value to be changed.
Use or to change the value, push again to confirm
it.
To adjust the second selection, use or to highlight it, then
repeat the above-mentioned steps.
Once water mixing for tea has been programmed, push repeatedly
to go back to main menu.
7-DOSES SET UP
This menu is used to program the coffee doses corresponding to the S1-
S2-S3-S4 buttons of each group and the hot water quantity
corresponding to S1-S2 buttons.
Push to access this menu.
7-1 Group 1
Push to enter the programming of the 4 pre-set dose buttons.
Extract a single coffee by pushing the S1 button of group 1, then push S1
again to stop extraction at desired dose. Repeat this operation on S2
(short double dose), S3 (long single dose), S4 (long double dose).
The new set values will be shown at the end of each programming
operation. Once group 1 has been programmed, push to go back
to previous menu.
To set up different doses on each group, follow the 7-1 instructions.
To Next Page
Loading...
