MANUALE INSTALLATORE RELEASE 00.1 PAG. 10
Push again to highlight the pre-set value, then use or
to change it, push again to confirm it and then to go
back to previous menu.
Push to go back to main menu.
6- MACHINE SET UP
Push to access this menu.
6-1 Group number
This menu is used to set the number of groups to be managed by
electronic control.
This menu is set up by the manufacturer depending on the number of
groups the electronic control must manage.
Push to access this menu.
Push again to highlight the set value, then use or to
change it, push again to confirm it and then to go back to
previous menu.
6-2 Steam
This menu is used to enable or disable the MCS.
Push to access this menu.
Push again to highlight the pre-set value, then use or
to change it, push again to confirm it and then to
go back to previous menu.
6-3 Serial number
This menu is used to enter the machine serial number, which is set by the
manufacturer.
To Next Page
Loading...
