MANUALE INSTALLATORE RELEASE 00.1 PAG. 2
This machine must be destined exclusively to the use it has been conceived for. Any other use
shall be considered improper and therefore unreasonable. The manufacturer cannot be held
responsible for any damages caused by improper, wrong or unreasonable use.
The electric, water, draining systems shall be arranged in a suitable position to allow correct
machine installation.
The installer cannot modify the existing systems (see chapter “setting up for installation” in the
“USER AND MAINTENANCE MANUAL” attached to each machine).
GENERAL NOTES
The instructions and warnings contained in this manual and in the “USER AND MAINTENANCE
MANUAL” shall be read carefully, since they provide important information on machine
installation and functioning.
Verify the user has arranged the systems following the instructions contained in the “USER AND
MAINTENANCE MANUAL” attached to the machine.
Check the user's electric system power capacity is sufficient for machine maximum power, as
indicated in its identification plate.
If power cable needs to be replaced, use the cable that is suggested by the manufacturer.
Machine electric safety is achieved only when the machine is correctly connected to a grounded
electric system.
The machine must be connected exclusively to an appropriate cold drinking water source. The
maximum incoming water pressure must be of 0.6 Mpa.
Moreover, some basic rules shall be followed when using any electric device:
• Do not use the machine if you have wet hands or feet
• Do not use the machine if you are barefoot
• Do not allow children or untrained people to use the machine
• Do not wash the machine under a water jet
• Do not leave the machine switched on and unattended
To Next Page
Loading...
