Version 06 teledynedalsa.com/ipd 14
The iDiscover
utility is provided for discovering BOA cameras connected to the local PC
network. iDiscover
is installed on the host system when a BOA camera is first
connected. It is also installed as part of the emulator installation.
The iDiscover
program can be launched in one of two ways:
iDiscover Utility
1.
If the connecting PC has previously been used to interface a BOA
camera, then
the iDiscover
program resides in the windows System32 directory. To invoke, open
the command prompt (“Start programs -> Run”), type “iDiscover”
and click “OK”
2.
If the connecting PC has not previously been used to interface a
BOA camera, you
must first install the iNspect
software emulator. Once installed, the program can be
invoked from the iDiscover
shortcut (“Start programs -> IPD iNspect
-> Discover
BOA Cameras”).
Once launched the GUI below will be shown. The left panel shows the MAC addresses
of all reachable BOA cameras. Click on one of these to populate the associated
network configuration on the right. You can then modify the BOA IP address (click
“Apply”) or connect to the associated camera (click “Connect To Device”).
To Next Page
Loading...
Need help?
General
