Need help?Do you have a question about the Dalsa Linea SWIR GigE Series and is the answer not in the manual?
General| Sensor Type | InGaAs |
|---|---|
| Interface | GigE Vision |
| Resolution | 1024 pixels |
| Pixel Size | 25 µm |
| Dynamic Range | 60 dB |
| Operating Temperature | 0°C |
| Power Requirements | 24VDC |
Provides detailed technical specifications for the camera models.
Details the sensor's performance characteristics and specifications.
Step-by-step instructions for connecting the camera to the network.
Outlines the automatic IP address assignment process for the camera.
Provides methods to prevent damage from electrostatic discharge.
Instructions for installing the Sapera API and related software.
Guidance on how to update the camera's firmware.
Instructions for using the Network Configuration Tool.
A basic guide to test the camera setup using CamExpert.
Guide to using CamExpert for camera control and testing.
Parameters for controlling sensor-specific settings like exposure and gain.
Explanation of gain and black level adjustments for image optimization.
Information on controlling the camera's exposure timing and modes.
Details on using internal signals to control exposure.
Details on using external signals to control exposure.
Explanation of the camera's trigger event mechanisms.
Features for replacing defective pixels in the image.
Correcting image non-uniformities using Flat Field Calibration.
Explanation of the Flat Field Correction (FFC) function.
Procedure for setting up Flat Field Correction.
Using the histogram tool to prepare black and bright images for FFC.
Steps to perform the Flat Field Correction calibration process.
Procedure for performing Fixed Pattern Noise (FPN) correction.
Procedure for performing Photo Response Non-Uniformity (PRNU) correction.
Instructions for upgrading camera firmware using CamExpert.
Details on various IP configuration modes for the camera.
Explanation of the Persistent IP address configuration mode.
Details the camera's Ethernet and I/O connectors.
Precautions regarding electrostatic discharge (ESD) and sensor damage.
Guidelines for protecting the sensor window from contamination.
Troubleshooting steps when the camera device is not detected.
Troubleshooting steps for camera IP address related errors.
Resolving issues when the camera is detected but not functioning optimally.
Steps to verify and configure network parameters for camera communication.
Steps to resolve issues when the camera cannot connect to the host PC.
Covers issues apparent after installation or indicated by the GigE server icon.
Procedures for updating the camera firmware.
Guidance on recovery after a power failure during firmware update.
Troubleshooting steps for cabling and communication problems.
Steps to diagnose and resolve communication issues.
Troubleshooting specific acquisition errors without timeout notifications.
Steps to diagnose why the camera is not exposing when expected.
Diagnosing why the camera's acquisition rate is lower than anticipated.
Troubleshooting when acquisition is good but rate is lower than expected.
Resolving issues where the image output is black despite correct settings.
Troubleshooting for buffer incomplete error messages.
To Next Page
