Dalsa Linea SWIR GigE Series User Manual

Linea SWIR GigE Series Camera Network Overview & Tools
•
91
Persistent IP
• This configuration allows the user full control of IP address assignment on the network.
• The camera is forced a static IP address. The NIC IP address must be the same to access the
camera.
• If the camera is connected to a network with a different subnet, it cannot be accessed.
• Use Teledyne DALSA’s Network Configuration Tool to set a persistent IP address. Refer to
Teledyne DALSA’s Network Imaging manual.
• An example of a Persistent IP address assignment on a class B network:
• NIC Subnet = 192.168.1.1
• Subnet Mask = 255.255.0.0
• Persistent IP = 192.168.1.2
• Default Gateway = 0.0.0.0
• Warning: An incorrect IP address assignment may block connecting to the camera. Use
Teledyne DALSA’s Network Configuration tool to recover a camera with an unknown persistent
IP. It will reset the camera’s factory default mode, DHCP/LLA. The camera’s MAC address
displayed on the exterior camera is required to perform this function.
• For GigE Vision applications, the FORCEIP command is used to force a new persistent IP or to
change the IP configuration protocol. The camera’s MAC address must be known to use the
FORCEIP command.
• The following illustration shows a functional computer setup with three NIC ports, but no DHCP
server. Two NIC ports are used for private GigE Vision networks. The first uses the default LLA
mode for IP addresses, while the second NIC and cameras connected to it are configured with
persistent IP addresses. An application on the computer can control each camera, on each
subnet, without conflict.
169.254.xxx.xxx
Subnet 169.254.xxx.xxx
Subnet mask 255.255.0.0
Subnet xxx.xxx.xxx.xxx
Subnet mask 255.255.0.0
xxx.xxx.xxx.xx3
Persistent IP Mode
NIC xxx.xxx.xxx.xx1
(default LLA mode)
NIC 169.254.xxx.xxx
PCI
Persistent IP Mode
NIC and cameras are manually assigned IP
addresses within the same Subnet
corporate network
with corporate DHCP
server
NIC xxx.xxx.xxx.xxx
Gigabit switch Gigabit switch
169.254.
xxx.xxx169.254.xxx.xxx
Default LLA mode
Attached cameras are automatically assigned
IP addresses on the NIC Subnet
xxx.xxx.xxx.xx2 xxx.xxx.xxx.xx4
Figure 47: Persistent IP Network

Dalsa Linea SWIR GigE Series Specifications

General

Brand	Dalsa
Model	Linea SWIR GigE Series
Category	Digital Camera
Language	English