Linea SWIR GigE Series Camera Using Linea SWIR GigE with the Sapera API
21
If you hover the mouse over the tray icon, the GigE Server will display the number of GigE Vision
devices found by the PC. Right click the icon and select ‘SHOW Status Dialog Box’ to view
information about those devices. See Running the Network Configuration Tool and Troubleshooting
for more information.
GigE Server Status
The Status LED turns steady blue after the Linea SWIR GigE camera is assigned an IP address and
the GigE server tray icon will indicate the device was found.
When a Linea SWIR GigE is connected a small camera icon is added to the Windows tray (adjacent
to clock) or in the tray pop up (Show hidden Icons). Right click the icon and select ‘SHOW Status
Dialog Box’ to confirm camera connection.
Figure 9: GigE Server Tray Icon Menu
GigE devices with assigned IP and MAC addresses are displayed. The screen shot below shows a
connected Linea SWIR GigE camera with no networking problems.
Figure 10: GigE Server Status Dialog
If the camera is physically connected, but the Sapera GigE Server icon is indicating that the
connected device is not recognized. Click ‘Scan Network’ to restart the discovery process.
Note: The GigE server periodically scans the network to refresh its state. See Troubleshooting to
resolve network problems.
Optimizing the Network Adapter used with Linea SWIR
GigE
Adjust parameters of the Gigabit network interface controllers (NIC) during the installation to
optimize its use with the Linea SWIR GigE.
Note: Refer to Sapera LT user’s manual for optimization information.
To Next Page
Loading...
