Dalsa Linea SWIR GigE Series User Manual

30
•
Operational Reference Linea SWIR GigE Series Camera
Load Configuration UserSetLoad Loads the camera configuration set specified by the
User Set Selector feature to the camera and makes it
active. (W)
1.00
Beginner
Save Configuration UserSetSave Saves the current camera configuration to the user
set specified by the User Set Selector feature. The
user sets are located on the camera in non-volatile
memory. (W)
1.00
Beginner
Device Built-In Self Test deviceBIST Command to perform an internal test which will
determine the device status. (W)
1.00
DFNC
Beginner
Device Built-In Self Test
Status
deviceBISTStatus Return the status of the device Built-In Self Test.
Possible return values are device-specific.
1.00
Beginner
Passed Passed No failure detected.
Firmware Update Failed FirmwareUpdateFailure Last firmware update operation failed.
FPGA Cyclic Redundancy
Check Failed
FPGA_CRC_Failure FPGA cyclic redundancy check failed.
Unexpected Error Unexpected_Error Switched to recovery mode due to unexpected
software error.
Device Built-In Self Test
Status All
deviceBISTStatusAll Return the status of the device Built-In Self Test as a
bitfield. The meaning for each bit is device-specific.
1.00
DFNC
Beginner
Device Reset DeviceReset Resets the device to its power up state. (W) 1.00
Beginner
Device Temperature
Selector
DeviceTemperatureSelector Select the source where the temperature is read. 1.00
Beginner
Device Temperature DeviceTemperature The temperature of the selected source in degrees
Celsius
1.00
Beginner
Device ID DeviceID Displays the device’s factory set serial number. 1.00
Invisible
Calibration Date deviceCalibrationDateRaw Date when the camera was calibrated. 1.00
DFNC
Invisible
Device Acquisition Type deviceAcquisitionType Displays the Device Acquisition Type of the product.
(RO)
1.00
DFNC
Invisible
Sensor Sensor The device gets its data directly from a sensor.
Device TL Type DeviceTLType Transport Layer type of the device. 1.00
Invisible
GigE Vision GigEVision GigE Vision Transport Layer
Device TL Version Major DeviceTLVersionMajor Major version of the device’s Transport Layer. 1.00
Invisible
Device TL Version Minor DeviceTLVersionMinor Minor version of the device’s Transport Layer. 1.00
Invisible
Power-up Configuration
Selector
UserSetDefaultSelector Selects the camera configuration set to load and
make active on camera power-up or reset. The
camera configuration sets are stored in camera
non-volatile memory. (RW)
1.00
Invisible
None None Keep Internal configuration.
Factory Setting Default Select the Factory Setting values as the Power-up
Configuration.
UserSet1 UserSet1 Select UserSet1.
UserSet2 UserSet2 Select UserSet2.
DFNC Major Rev deviceDFNCVersionMajor Major revision of Dalsa Feature Naming Convention
which was used to create the device’s XML. (RO)
1.00
DFNC
Invisible
DFNC Minor Rev deviceDFNCVersionMinor Minor revision of Dalsa Feature Naming Convention
which was used to create the device’s XML. (RO)
1.00
DFNC
Invisible

Dalsa Linea SWIR GigE Series Specifications

General

Brand	Dalsa
Model	Linea SWIR GigE Series
Category	Digital Camera
Language	English