Dalsa P-2 Series - Setting the Exposure Mode

28 Piranha2 User’s Manual
2. Then, when applicable, use the commands ssf (mode 2 only) to set the line rate
and/or
set (mode 2 or 6), to set the exposure time. Refer to Setting Line Rate and
Setting Exposure Time below for details.
Setting the Exposure Mode
To select an exposure mode, use the command:
Syntax:
sem i
Syntax Elements:
i
Exposure mode to use. Factory setting is 1. Refer to
Table 9 on page 27 for a list of available modes.
Notes: To obtain the current value of the exposure mode, use the
command
gcp.
Related Commands:
ssf, set
Example:
sem 3
Setting Line Rate
Camera must be operating in exposure mode 2.
To set the line rate, use the command:
Syntax:
ssf i
Syntax Elements:
i
Desired line rate in Hz. Allowable range is 1000Hz to the
camera’s maximum line rate. See Table 1. Piranha2
Operating Requirements and Ranges for maximum line
rates.
Notes:
• To read the current line rate frequency, use the command
gcp.
• If you enter an invalid line rate frequency, the valid range of
values will be displayed.
Related Commands:
sem, set
Example:
ssf 3000
03-32-00493-11 DALSA