Dalsa Spyder2 - Page 60

60 Spyder2 User’s Manual
03-032-10091-06 Teledyne DALSA
GCP Screen Description
command had been i ssued.
SETTINGS COMMON TO CALIBRATED AND UNCALIBRATED MODES:
System Gain: 0
Digital gain value set with the
ssg command. See section
3.13
Set ting Gains for details.
Background Subtract: 0
Background subtract val ue set
with the ssb command. See
section 3.12 Optimizing Offset
Performance for details.
Pretrigger: 0
Pr etrigger v alue set with the sp
command . See secti on 3.20
Setting the Pre-trigger for
details.
Number of Line
Samples:
64
N umber of l i nes sampl es set
with the css command. See
section 3.11 Returning Video
Information for details.
Video Mode: uncalibrated
Current video mode val ue set
with the svm command. See
section 3.8 Setti ng the Video
Mode for details.
Data Mode: 0
Current data mode value set
with the sdm command. See
section 3.7 Setting the Data
Mode for details.
Exposure Mode: 2
Current exposur e mod e v al ue
set with the sem command. See
section
3.9 Setting Line Rate and
Exposure Mode for details.
SYNC Frequency: 5000 (4998.51) Hz
Current line r ate. Val ue is set
with the ssf command. See
section 3.9 Setting Line Rate and
Exposure Mode for details.
Exposure Time: 197.950 uSec
Current exposur e time setting.
Value is set w i th the set
command . See secti on 3.9
Setting Line Rate and Exposure
Mode for details.
End-Of-Line Sequence: on
States w hether an end of l i ne
sequence is tur ned on or of f.
Set using the eol command.
See secti on 3.17 Test Patterns
for details.
Upper Threshold: 240
Upper thr eshold value set w ith
the
sut
command.
Lower Threshold: 15
Low er threshold value set w ith
the
slt
command.