Dalsa Spyder2 - Page 62

62 Spyder2 User’s Manual
03-032-10091-06 Teledyne DALSA
Code Command Short
Form
Parameters Description
4 correction_set_sample
css i
Set number of l i ne sampl es
averaged for pixel coeffi ci ent
calculations or for output of
gla command. Values: 16, 32,
64
(default).
5 display_pixel_coeffs
dpc [i] [i]
Display the pixel coefficients
in the or der FPN , PRN U, FPN ,
PRNU, … Optional pixel start
and end values in a range from
1 to sensor pixel count.
6 endof_line_sequence
els i
Set the end-of-l i ne sequence:
0: Off
1
: On, defaul t value
7 get_camera_id
gci
Read the camera ID.
8 get_camera_model
gcm
Read the camera model
number.
9 get_camera_parameters
gcp
Read camera par ameters.
10 get_camera_serial
gcs
Read the camera seri al
number.
11 get_camera_version
gcv
Read the fi r mw are version and
FPGA v er si on.
12 get_fpn_coeff
gfc i
Read the FPN coef fici ent for
the pi xel i ndi cated by the
parameter in a range from 1 to
the sensor pi xel count.
14 get_line
gl [i] [i]
Get a li ne of raw video (no
digital processing or test
pattern) displaying one pixel
val ue after another and the
minimum, maximum, and
mean val ue of the sampl ed
line. Optional pixel start and
end values in a range from 1 to
sensor pi xel count.
15 get_line_average
gla [i] [i]
Read the average of li ne
sampl es. Use css to set
sample size. Optional pixel
start and end values in a range
from 1 to sensor pixel count.
13 get_pr nu_coeff
gpc i
Read the PRN U coeffi cient for
the pi xel i ndi cated by the
parameter in a range from 1 to
the sensor pi xel count.
16 get_processi ng_status
gps
Read the status of last
executed command and coded
value for all pending
monitoring task warnings.
17 get_sensor_serial
gss
Read the sensor ser i al number.