Danby DPAC10071 - Page 11

Air Conditioner
Operating Instructions
(cont’d)
4)
Press
the
FAN
key Fig F
(1)
to
select the desired
fan
speed setting (Auto-Low-Med-High).
Your
selection will
appear in the
display
window
(each
depression of the
fan key will advance
to a different
setting).
5) Press the
SWING key Fig F
(2) to
activate the
automatic
air swing (oscillating)
feature and the
swing symbol will
appear in the
display
window.
Fig
G. To deactivate
the
air
swing
feature,
press
the
SWING key
again.
6)
The
horizontal louvers
open and
close
automatically
when
the
unit
is switched
on
and off.
To
adjust “air
flow”
direction,
(up / down
only) adjust
the
center
louver only
up
or down
Fig
16.
The
blue
indicator
light will
come on
indicating
the
air-conditioning
mode is
operational
(there may
be
a
slight delay
of 10-30 seconds
before
the cycle
begins, this
is
normal).
Cooling
stops automatically
when
the
set
temperature
is
achieved. Cooling
resumes when
the
room
temperature
rises above
the
set
temperature
level.
The
temperature has
no effect
on
the fan
operation.
Therefore,
the fan
will operate
continuously
(after
the compressor has cycled
off)
to
maintain
optimal temperature
control.
FI,
i”?
V
-\
Fig. 16
—
A
ATTENTION
A
When
the unit beeps and
the (red) “water full”
indicator
light illuminates
and
flashes continuously,
please
(re)install the external
water tank.
A
CAUTION
A
During
air conditioning
and
dehumidifying
modes,
if the
compressor
cycle is interupted
(unplugged,
power failure,etc.)
and
reinstated
immediately
thereafter, (within
3-5
minutes)
a
“compressor
protection circuit”
is
automatically
self-activated.
The compressor
cannot operate
during
a
“compressor protecton”
condition.
(this
is
normal)
It
may take 3-5
minutes before
the
“protection
circuit” self-deactivates.
DO
NOT
ATTEMPT
TO
START THE
UNIT
(COMPRESSOR)
DURING
THIS PERIOD.
Upon
reinstating
power
to the unit all previous
settings
(i.e.
time,
mode,
fan
speed,
auto
timed
programs)
are lost
and will
have
to be
re-entered.
10