d&b audiotechnik D12 - Device Name; Display; Information

Device Name
Enables the assignment or editing of a device name (maximum 15
characters):
1. Selecting "Device Name" enters the sub-menu and the cursor is
positioned at the beginning of the "Device Name". As a factory
preset "D12" followed by the firmware version is entered.
2. Pushing the encoder enters edit mode. The pointer, (
), indicates the
entry position for new or edited characters. A variety of characters
(e.g. capital and lower case letters, numbers 0-9 and special
characters) is displayed in the bottom line.
3. By turning the encoder, each character can be highlighted. Turning
left moves the cursor to the beginning of the list (A ⇐), turning right
to the end of the list (⇒ @).
4. By pushing the encoder, the highlighted letter is entered in the upper
line and the pointer advances one place.
5. Repeat steps 1 to 4 until the complete device name is entered.
6. Exit edit mode by moving the cursor to the return sign (
) and
pushing the encoder.
Notes:
An existing entry can be completed by the return sign at any position.
Succeeding letters are deleted automatically.
Single characters can be kept by simply pushing the encoder, the
pointer advancing one place after each entry.
The editing position can be scrolled through the characters by pushing
and turning the encoder simultaneously.
Ok
Selecting "Ok" and pushing the encoder will confirm the new setting
and exit the sub-menu "Device name".
Cancel (⇒ Back
)
Exits the sub-menu leaving the previous device name installed.
Display
Selecting "Display" and pushing the encoder enters the sub-menu
"Display Options".
Display Options
Contrast
Enables adjustment of the display contrast.
Backlight
Enables the following settings:
off: display illumination permanently off.
On: display illumination permanently on.
timeout 10s: display is illuminated when the encoder or a MUTE
switch is pressed and switches off 10 seconds after
the last operation.
Note:
In "Standby mode" the display illumination reverts to "timeout 10s".
Information
Selecting "Information" and pushing the encoder enters the sub-menu.
Temp. Amp.
The temperature of the D12 heat sink.
D12 Software manual (Firmware V2.x.x) (5.2EN) Page 23 of 36
Device Name
Stage righ
Stage righ
t
jklmnopqrstuvwxyzäöüß01
Stage right
TUVWXYZÄÖÜ abcdefgh
Device Name
Device Name
Stage right
Ok Cancel
Information
Display Options
Back
Contrast
5
Backlight on
Device Name
D12
X2.0.xx
Ok Cancel
Display