Amp Prot
A numerical value indicating the number of times the D12 has entered
the error condition "Amp Protect", possibly due to a current overload
caused by a low impedance or short circuit connected to the output.
Amp Err
A numerical value indicating the number of times the D12 has entered
the error condition "Amp Error" due to an internal fault.
Temp Off
A numerical value indicating the number of times the D12 has switched
off with the error condition "Overtemperature" due to overheating.
ImpErrLf
A numerical value indicating the number of times the D12 has entered
the error condition "ImpErrLf" due to a Load Monitoring fault.
ImpErrHf
A numerical value indicating the number of times the D12 has entered
the error condition "ImpErrHf" due to a Load Monitoring fault.
InpMonErr
A numerical value indicating the number of times the D12 has entered
the error condition "InpMonErr" due to a Input Monitoring fault,
possibly caused by a missing external pilot signal.
T/S Mis.
A numerical value indicating the number of times the D12 has entered
the error condition "T/S Mis." due to a TOP/SUB mismatch at the output
connectors of the D12 in Dual Channel mode as long as the "TSM
Detection" function was not set to off.
DSP Halt
A numerical value indicating the number of times the D12 has entered
the error condition "DSP Halt" due to a internal fault.
Temp. (Temperature Log)
Proportionate temperature ranges.
These display the proportion of "On Time" the D12 has been operated
within the temperature ranges listed.
D12 Software manual (Firmware V2.x.x) (5.2EN) Page 26 of 36
To Next Page
Loading...
