Danfoss APP series - Page 58

40
180R9265 / IOM APP 16-22 Appendices - v02 / 01.2013
Parts list APP 0.6-38 / APM 0.8-2.9 / APPW 5.1-10.2
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice.
This also applies to products already on order provided that such alterations can be made without subsequential changes being necessary in specications already agreed.
All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
23. Tool sets
Danfoss A/S
High Pressure Pumps
DK-6430 Nordborg
Denmark
Designation
180B4188 – Tool set (APP 0.6-1.0 Compact) 180B4142 – Tool set (APP 0.6-1.0) 180B4148 – Tool set (APP 1.5-3.5) 180B4162 – Tool set (APP 5.1-10.2) 180B4230 - Tool set (APP 11-13) 180B4222 – Tool set (APP 16-22) 180B4172 – Tool set (APP 21-38)
Shaft bush x
Press bush x
Drift x
Torx T30 x
Shaft bush Ø18 xx
Press Bush Ø18 xx
Allen Key 4mm x
Allen Key 5mm x
Allen Key 6mm xxxx
Shaft bush Ø35 x
Shaft seal extractor Ø35 xx
Press bush Ø35 xx
Adjustable pin wrench xxxx
Combination wrench 10mm xxxx
Combination wrench 13mm xxx
Nut M8x6.5x13 xxx
Guide bolt M8x140mm x
Shaft seal extractor Ø45 xx
Press Bush Ø45 xx
Eye bolt M8 xx
Press bush for valve plate xx
Stop for retainer plate x
Screw M8x20 xxx
Screw M8x70 xx
Screw M8x140 x
Lifting eye x
Note:
The parts listed are not sold
separately, only in various kits.
Tool sets