Configuring the ECL 2000
EI.65.D4.02
22
5.3 Selecting an Application
This section explains how to select one of the ECL 2000’s pre-programmed appli-
cations.
To select an application:
1. Press the front panel
button.
If no application has been selected, the ECL 2000
displays the picture Application 1. However, if an
application has already been selected, the picture of
this application is displayed. In this case, the pic-
ture’s title is inverted, i.e. displayed in light charac-
ters on a dark background.
2. Use and
to browse through available
applications.
Each application picture shows a diagram of the
system configuration. System diagrams offering ad-
ditional detail are provided in Chapter 6.
When you have found the application you need:
3. Keep the
button depressed for a few sec-
onds.
While the
button is active, the picture’s title (in
the example “APPLICATION 10”) is inverted, one
character at a time, until the whole title is displayed
in light characters on a dark background.
When all the characters of the title are inverted, this
indicates that the controller is configured to use this
application.
The
symbol appears briefly, indicating that you
can access further configuration pictures. After a
moment, the controller automatically displays the
first configuration picture
(see next page).
!
Note:
You only need to perform further configuration if you wish to:
• Connect extra sensors to the controller
• Change the default function of sensors
• Change the default function of outputs.
Chapter 6 tells you which inputs and outputs can be customized for the individual
applications.
To Next Page
Loading...
Need help?
General
