Danfoss ECtemp Next Plus User Manual

Danfoss ECtemp Next Plus
7Installation Guide
• Place the oor sensor in a conduit in an appropriate place
where it is not exposed to sunlight or draft from door
openings.
• Equally distant and >2cm from two heating cables.
• The conduit should be ush with the oor surface -
countersink the conduit if necessary.
• Route the conduit to the connection box.
• The bending radius of the conduit must be min 50mm.
Connect the thermostat according to the connection
diagram.
The screen of the heating cable must be connected to
the earth conductor of the power supply cable by using a
separate connector.
Note: Always install the oor sensor in a conduit in the
oor.

Danfoss ECtemp Next Plus Specifications

General

Voltage	220 - 240 V
Temperature range (T-T)	-10 - 60 °C
Temperature control range	5 - 45 °C
Power source	AC
Power consumption (standby)	2 W
Product color	White
Memory function	-
Housing material	Plastic
Smart thermostat	Yes
International Protection (IP) code	IP30

Weight and Dimensions

Depth	16 mm
Width	86 mm