Danfoss ECtemp Next Plus User Manual

Danfoss ECtemp Next Plus
Installation Guide6
2 Mounting Instructions
Please observe the following placement guidelines:
Place the thermostat at a suitable height on the wall
(typically 80-170cm.).
The thermostat should not be placed in wet rooms.
Place it in an adjacent room and use oor sensor
only. Always place the thermostat according to local
regulation on IP classes and use oor sensor only.
Do not place the thermostat on the inner side of an
exterior wall.
Always install the thermostat at least 50 cm. from
windows and doors.
Do not place the thermostat in a way that it will be
exposed to direct sunlight.
Note: A oor sensor enables a more accurate
temperature control and is recommended in all oor
heating applications and mandatory under wooden
oors to reduce the risk of over-heating the oor.

Danfoss ECtemp Next Plus Specifications

General

Voltage	220 - 240 V
Temperature range (T-T)	-10 - 60 °C
Temperature control range	5 - 45 °C
Power source	AC
Power consumption (standby)	2 W
Product color	White
Memory function	-
Housing material	Plastic
Smart thermostat	Yes
International Protection (IP) code	IP30

Weight and Dimensions

Depth	16 mm
Width	86 mm