Danfoss ECtemp Next Plus

Danfoss ECtemp Next Plus
9Installation Guide
4 Settings
4�1 Power ON/OFF
Switch thermostat ON/OFF by pressing button on top of
thermostat.
4�2 Initial Settings
Initial settings must be specied when the unit is activated
for the rst time:
Press M button for 6 seconds to enter the parameter setting
mode.
The upper digits indicate the parameter number.
Press M for parameter selection.
Press < or > to set the parameter range.
Complete all adjustments.
Press to exit ECtemp Next Plus settings, which is available
for this purpose.
To exit ECtemp Next settings automatic wait approx. 30
seconds.