To Next Page
J
Jonathan LewisAug 9, 2025
Why Danfoss EET compressor does not start?
- SSarah OrtizAug 10, 2025
The compressor might not start because the spindle is in the “OFF” position; in this case, change the spindle position by rotating clockwise. It could also be due to waiting for power on delay, so check and wait until “Pod” expires. Other potential causes include: the cabinet air temperature is less than the compressor cut-in temperature (check cabinet air sensor temp. “att”), defrost is in progress (check and wait until dAt and dot expires), the line voltage is too low or too high (check line voltages are within low and high voltage limits specified under uLi, uLo and uHo), or high condenser temperature (check for condenser sensor temp’ct1’ and configured condenser block limit’cbL’).
General
