Illustration 4.40:
Step 6: The speed of the motor can be seen in the LCP. It
can be adjusted by pushing the up
▲
and down
▼
arrow
buttons.
Illustration 4.41:
Step 7: To move the cursor, use the left ◄ and right ►
arrow buttons. This enables changing the speed in larger
increments.
Illustration 4.42:
Step 8: Press the [Off] button to stop the motor again.
Illustration 4.43:
Step 9: Change two motor wires if the desired rotation of
direction is not achieved.
Remove mains power from the frequency converter
before changing motor wires.
Electrical Installation
VLT
®
HVAC Drive Operating Instructions
MG.11.AD.02 - VLT
®
is a registered Danfoss trademark 43
4
To Next Page
Loading...
