Danfoss VLT AQUA Drive - Page 158

Pipe Fill Speed [hz], 29-02 98
Pipe Fill Speed [rpm], 29-01 98
Pipe Fill Time, 29-03 98
Preset Reference 73
Pressure At No-flow Speed, 22-87 93
Pressure At Rated Speed, 22-88 93
Profibus 109
Profibus Dp-v1 60
Protection 23
Protection And Features 144
Pulse Width Modulation 150
Q
Q1 My Personal Menu 62
Q2 Quick Setup 62
Q3 Function Setups 63
Q5 Changes Made 65
Q6 Loggings 65
Quick Menu 52, 61
Quick Menu Mode 52
Quick Transfer Of Parameter Settings When Using Glcp 57
R
Ramp 1 Ramp-down Time, 3-42 74
Ramp-up Time 1 Parameter, 3-41 74
Reference / Ramps 104
Reference/feedback Unit, 20-12 85
Relay Outputs 146
Reset 53
Residual Current Device 6
Rise Time 149
Rs-485 Bus Connection 58
S
Safety Note 5
Screened/armoured. 40
Serial Communication 147
Set Date And Time, 0-70 71
Setpoint 1, 20-21 86
Sfavm 150
Sine-wave Filter 32
Smart Logic 111
Special Functions 112
Speed At Design Point [hz], 22-86 93
Speed At Design Point [rpm], 22-85 93
Speed At No-flow [hz], 22-84 93
Speed At No-flow [rpm], 22-83 93
Square-linear Curve Approximation, 22-81 91
Start/stop 45
Stator Frequency Asyncron Vector Modulation 150
Stator Leakage Reactance 73
Status 52
Status Messages 49
Step-by-step 56
Submersible Pump 46
Surroundings 147
Switches S201, S202, And S801 41
T
Terminal 32 Digital Input, 5-14 79
Terminal 33 Digital Input, 5-15 79
Terminal 42 Output Max Scale 6-52 84
Terminal 42 Output Min Scale, 6-51 84
Terminal 42 Output, 6-50 83
Terminal 53 High Voltage, 6-11 82
Index
VLT
®
AQUA Drive
Operating Instructions
158 MG.20.M4.02 - VLT
®
is a registered Danfoss trademark