Danfoss vlt aqua - Page 146

22-33 Low Speed [Hz]
Range: Function:
Application
dependent*
[Application dependant]
22-34 Low Speed Power [kW]
Range: Function:
Application
dependent*
[Application dependant]
22-35 Low Speed Power [HP]
Range: Function:
Application
dependent*
[Application dependant]
22-36 High Speed [RPM]
Range: Function:
Application
dependent*
[Application dependant]
22-37 High Speed [Hz]
Range: Function:
Application
dependent*
[Application dependant]
22-38 High Speed Power [kW]
Range: Function:
Application
dependent*
[Application dependant]
22-39 High Speed Power [HP]
Range: Function:
Application
dependent*
[Application dependant]
22-40 Minimum Run Time
Range: Function:
10 s* [0 - 600 s] Set the desired minimum running time for the motor after a start command (digital input or bus)
before entering sleep mode.
22-41 Minimum Sleep Time
Range: Function:
10 s* [0 - 600 s] Set the desired minimum time for staying in sleep mode. This will override any wake-up conditions.
22-42 Wake-up Speed [RPM]
Range: Function:
Application
dependent*
[Application dependant]
5 How to program the adjustable frequency
drive
VLT AQUA High Power Instruction Manual
5-40 MG.20.P3.22 - VLT
®
is a registered Danfoss trademark
5