Danfoss vlt aqua - Page 204

Serial Communication Bus Connection 3-64
Set Date And Time, 0-70 5-13
Setpoint 1 20-21 5-36
Setpoint Boost 22-45 5-41
Shielded Cables 3-54
Shielded/armored 3-70
Shielding Of Cables: 3-43
Sine-wave Filter 3-43
Software Version And Approvals 2-7
Space 3-14
Space Heaters And Thermostat 3-39
[Speed At Design Point Hz] 22-86 5-44
[Speed At Design Point Rpm] 22-85 5-44
[Speed At No-flow Hz] 22-84 5-44
[Speed At No-flow Rpm] 22-83 5-44
Speed Up/down 3-68
Square-linear Curve Approximation 22-81 5-42
Start/stop 3-67
Stator Leakage Reactance 5-16
Status 4-4
Status Messages 4-1
Step-by-step 4-10
Stopping Category 0 (en 60204-1) 2-4
Surroundings 6-4
Switches S201, S202, And S801 3-72
Switching Frequency: 3-43
T
Term. 29 High Ref./feedb. Value 5-53 5-30
Terminal 27 Digital Output 5-30 5-27
Terminal 27 Mode 5-01 5-21
Terminal 32 Digital Input 5-14 5-25
Terminal 33 Digital Input 5-15 5-26
Terminal 42 Output 6-50 5-32
Terminal 42 Output Max Scale 6-52 5-34
Terminal 42 Output Min Scale 6-51 5-33
Terminal 53 High Ref./feedb. Value 6-15 5-32
Terminal 53 High Voltage 6-11 5-32
Terminal 53 Low Ref./feedb. Value 6-14 5-32
Terminal 53 Low Voltage 6-10 5-32
Terminal 54 High Ref./feedb. Value 6-25 5-32
Terminal 54 High Voltage 6-21 5-32
Terminal 54 Low Ref./feedb. Value 6-24 5-32
Terminal 54 Low Voltage 6-20 5-32
Terminal Locations 3-17
Terminal Locations - Frame Size D 3-1
Time Format 0-72 5-14
Timed Actions, 23-0* 5-45
Torque 3-54
Torque Characteristics 6-1
Torque For Terminals 3-54
U
Unpacking 3-3
V
Voltage Level 6-1
Voltage Reference Via A Potentiometer 3-68
Index VLT AQUA High Power Instruction Manual
8-6 MG.20.P3.22 - VLT
®
is a registered Danfoss trademark