3.2 Applying Power to the Adjustable Frequency Drive
4-3
3.3 Basic Operational Programming
4-3
3.4 Automatic Motor Adaptation
4-4
3.5 Check Motor Rotation
4-5
3.6 Check Encoder Rotation
4-5
3.7 Local Control Test
4-5
3.8 System Start-up
4-6
4 User Interface
5-1
4.1 Local Control Panel
5-1
4.1.1 LCP Layout 5-1
4.1.2 Setting LCP Display Values 5-2
4.1.3 Display Menu Keys 5-2
4.1.4 Navigation Keys 5-3
4.1.5 Operation Keys 5-3
4.2 Backup and Copying Parameter Settings
5-3
4.2.1 Uploading Data to the LCP 5-4
4.2.2 Downloading Data from the LCP 5-4
4.3 Restoring Default Settings
5-4
4.3.1 Recommended Initialization 5-4
4.3.2 Manual Initialization 5-4
5 About Adjustable Frequency Drive Programming
6-1
5.1 Introduction
6-1
5.2 Programming Example
6-1
5.3 Control Terminal Programming Examples
6-2
5.4 International/North American Default Parameter Settings
6-3
5.5 Parameter Menu Structure
6-4
5.5.1 Main Menu Structure 6-5
5.6 Remote Programming with MCT 10 Set-up Software
6-9
6 Application Set-Up Examples
7-1
6.1 Introduction
7-1
6.2 Application Examples
7-1
7 Status Messages
8-1
7.1 Status Display
8-1
7.2 Status Message Definitions Table
8-1
8 Warnings and Alarms
9-1
Contents
VLT
®
AutomationDrive Instruction
Manual
MG.33.AI.22 - VLT
®
is a registered Danfoss trademark
To Next Page
Loading...
