2.4 Electrical Installation
This section contains detailed instructions for wiring the Adjustable frequency drive. The following tasks are described.
•
Wiring the motor to the Adjustable frequency drive output terminals
•
Wiring the AC line power to the Adjustable frequency drive input terminals
•
Connecting control and serial communication wiring
•
After power has been applied, checking input and motor power; programming control terminals for their intended
functions
Figure 2.4 Basic Wiring Schematic Drawing.
A=Analog, D=Digital
Terminal 37 is used for Safe Stop. For Safe Stop installation instructions, refer to the Design Guide.
* Terminal 37 is not included in AutomationDrive FC 301 (except frame size A1). Relay 2 and terminal 29 have no function
in AutomationDrive FC 301.
Installation
VLT
®
AutomationDrive Instruction
Manual
MG.33.AI.22 - VLT
®
is a registered Danfoss trademark 2-3
2
2
To Next Page
Loading...
