4.3.6 Terminal Locations - Frame size E
Take the following position of the terminals into consideration when designing the cable access.
Illustration 4.14: Terminal locations E3 - filter
Section shown
↓
Illustration 4.15: Terminal locations E6 - drive
Section shown
↓
Note that the power cables are heavy and difficult to bend. Consider the optimum position of the frequency converter for ensuring easy installation of
the cables.
Each terminal allows use of up to 4 cables with cable lugs or use of standard box lug. Earth is connected to relevant termination point in the drive.
4 How to Install
VLT HVAC Low Harmonic Drive Operating In-
structions
30 MG.16.A1.02 - VLT
®
is a registered Danfoss trademark
4
To Next Page
Loading...
