Danfoss VLT FC Series

6.1.4 ECB Drive or Bypass Selection
Use the LCP to switch between the motor running in drive
mode or bypass when operating in local control. The
display in operating mode is shown in Illustration 6.5.
1. Press [Drive Bypass]. Display changes to show
bypass and drive mode options (shown in Step
2).
1
2
3
130BX234.11
Illustration 6.5 LCP in Operating Mode
1
Display
2 Info key
3 Drive/Bypass Option Key
Table 6.6 Legend to Illustration 6.5
2. When running in drive mode, press [OK] on LCP
to activate bypass mode or press [Cancel] to
remain in drive mode. In bypass, motor will run
at full speed.
130BX237.10
Illustration 6.6
3. When running in bypass mode, press [OK] key on
keypad to activate drive mode or press [Cancel]
to remain in bypass mode.
130BX235.10
Illustration 6.7
4. Press [Status] to return to drive status display.
130BX236.10
Illustration 6.8
NOTE
Pressing [Info] at any time displays tips and guidelines for
performing the function currently activated.
130BX238.10
Illustration 6.9
Electronically Controlled B... Option Panel Operating Instructions
48 MG14I102 - VLT
®
is a registered Danfoss trademark
6
6