Danfoss VLT HVAC Drive FC 102 Programming Guide

1 Introduction
1.1 Supported Software Versions
Supported software versions: 9.12 and 48.9X
This programming guide can be used for all FC 301 and FC 302 drives, and for VLT® Decentral Drive FCD 302. The software version
number can be read from parameter 15-43 Software Version.
1.2 Integrated Motion Controller
The integrated motion controller (IMC) enables position control. For more information about IMC, refer to the Chapter Integrated
Motion Controller.
AU275636650261en-000101 / 130R033412 | Danfoss A/S © 2022.12
Introduction
VLT AutomationDrive FC 301/302
Programming Guide

Danfoss VLT HVAC Drive FC 102 Specifications

General

Enclosure	IP20, IP21, IP55
Ambient Temperature Range	-10°C to +40°C
Storage Temperature Range	-25°C to +70°C
Relative Humidity	5-95% (non-condensing)
Communication Protocols	Modbus RTU, BACnet, Profibus
Certifications	CE, UL, cUL
Control Principle	PWM
Cooling Method	Forced air cooling
Input Voltage	200-240V, 380-480V, 525-600V
Control Modes	sensorless vector control, closed loop vector control