Danfoss VLT HVAC Drive FC 102 Programming Guide

Operating variable
Unit
Parameter 16-11 Power [hp]
[hp]
Parameter 16-12 Motor Voltage
[V]
Parameter 16-13 Frequency
[Hz]
Parameter 16-14 Motor current
[A]
Parameter 16-15 Frequency [%]
%
Parameter 16-16 Torque [Nm]
Nm
Parameter 16-17 Speed [RPM]
[RPM]
Parameter 16-18 Motor Thermal
%
Parameter 16-20 Motor Angle
Parameter 16-21 Torque [%] High Res.
%
Parameter 16-22 Torque [%]
%
Parameter 16-23 Motor Shaft Power [kW]
kW
Parameter 16-24 Calibrated Stator Resistance
Ω
Parameter 16-25 Torque [Nm] High
Nm
Parameter 16-30 DC Link Voltage
V
Parameter 16-32 Brake Energy /s
kW
Parameter 16-33 Brake Energy Average
kW
Parameter 16-34 Heatsink Temp.
°C
Parameter 16-35 Inverter Thermal
%
Parameter 16-36 Inv. Nom. Current
A
Parameter 16-37 Inv. Max. Current
A
Parameter 16-38 SL Controller State (This is an array parameter with the selections 16-38.0–16-38.3).
Parameter 16-39 Control Card Temp.
°C
Parameter 16-40 Logging Buffer Full
Parameter 16-42 Service Log Counter
Parameter 16-43 Timed Actions Status
Parameter 16-45 Motor Phase U Current
A
Parameter 16-46 Motor Phase V Current
A
Parameter 16-47 Motor Phase W Current
A
Parameter 16-48 Speed Ref. After Ramp [RPM]
RPM
Parameter 16-49 Current Fault Source
Parameter 16-50 External Reference
AU275636650261en-000101 / 130R033422 | Danfoss A/S © 2022.12
How to Program
VLT AutomationDrive FC 301/302
Programming Guide

Danfoss VLT HVAC Drive FC 102 Specifications

General

Enclosure	IP20, IP21, IP55
Ambient Temperature Range	-10°C to +40°C
Storage Temperature Range	-25°C to +70°C
Relative Humidity	5-95% (non-condensing)
Communication Protocols	Modbus RTU, BACnet, Profibus
Certifications	CE, UL, cUL
Control Principle	PWM
Cooling Method	Forced air cooling
Input Voltage	200-240V, 380-480V, 525-600V
Control Modes	sensorless vector control, closed loop vector control