Danfoss VLT Micro Drive

ALARM 91, Parameter value is not valid in this mode
Occurs when trying to write an illegal value to a
parameter.
ALARM 92, Parameter value exceeds the min/max limits
Occurs when trying to set a value outside the range.
Parameter can only be changed when the motor is
stopped. Err. A wrong password was entered, occurs when
using a wrong password for changing a password-
protected parameter.
Troubleshooting
VLT
®
Micro Drive FC 51 Programming Guide
68 MG02C602 - VLT
®
is a registered Danfoss trademark
6
6