Danfoss VLT Midi Drive FC 280

5.2.24 37-** Application Settings
Param
eter #
Parameter description Default value 4 set-up Change during
operation
Conversion
index
Type
37-0* ApplicationMode
37-00 Application Mode [0] Drive mode 1 set-up FALSE - Uint8
37-1* Position Control
37-01 Pos. Feedback Source [0] 24V Encoder 1 set-up FALSE - uint8
37-02 Pos. Target 0 N/A 1 set-up FALSE 0 Int32
37-03 Pos. Type [0] Absolute 1 set-up FALSE - uint8
37-04 Pos. Velocity 100 RPM 1 set-up FALSE 67 uint16
37-05 Pos. Ramp Up Time 5000 ms 1 set-up FALSE -3 uint32
37-06 Pos. Ramp Down Time 5000 ms 1 set-up FALSE -3 uint32
37-07 Pos. Auto Brake Ctrl [1] Enable 1 set-up TRUE - uint8
37-08 Pos. Hold Delay 0 ms 1 set-up TRUE -3 uint32
37-09 Pos. Coast Delay 200 ms 1 set-up TRUE -3 uint16
37-10 Pos. Brake Delay 200 ms 1 set-up TRUE -3 uint16
37-11 Pos. Brake Wear Limit 0 N/A 1 set-up TRUE 0 uint32
37-12 Pos. PID Anti Windup [1] Enable 1 set-up TRUE - uint8
37-13 Pos. PID Output Clamp 1000 N/A 1 set-up TRUE 0 uint16
37-14 Pos. Ctrl. Source [0] DI 1 set-up TRUE - uint8
37-15 Pos. Direction Block [0] No Blocking 1 set-up TRUE - uint8
37-17 Pos. Ctrl Fault Behaviour
[0] Ramp
Down&Brake 1 set-up FALSE - uint8
37-18 Pos. Ctrl Fault Reason [0] No Fault 1 set-up TRUE - uint8
37-19 Pos. New Index 0 N/A 1 set-up TRUE 0 uint8
Parameter Lists
VLT
®
Midi Drive FC 280
132 Danfoss A/S © 12/2015 All rights reserved. MG07C102
55