Danfoss VLT Midi Drive FC 280 Programming Guide

3.1.4 Main Menu on NLCP
The Main Menu gives access to all parameters.
1. To enter Main Menu, press [Menu] until the
indicator in the display is placed above Main
Menu.
2.
[
▲
] [
▼
]: Browse through the parameter groups.
3. Press [OK] to select a parameter group.
4.
[
▲
] [
▼
]: Browse through the parameters in the
specic group.
5. Press [OK] to select the parameter.
6.
[►] and [
▲
] [
▼
]: Set/change the parameter value.
7. Press [OK] to accept the value.
8. To exit, press either [Back] twice (or 3 times for
array parameters) to enter Main Menu, or press
[Menu] once to enter Status.
See Illustration 3.5, Illustration 3.6, and Illustration 3.7 for the
principles of changing the value of continuous,
enumerated, and array parameters, respectively. The
actions in the illustrations are described in Table 3.5,
Table 3.6, and Table 3.7.
130BC446.10
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
1
2
3
4
5
6
7
10
11
12
OK
OK
Back
8
Back
Setup 1
2 x
+
OK
9
OK
Illustration 3.5 Main Menu Interactions - Continuous
Parameters
Programming
VLT
®
Midi Drive FC 280
16 Danfoss A/S © 12/2015 All rights reserved. MG07C102
33

Danfoss VLT Midi Drive FC 280 Specifications

General

Brand	Danfoss
Model	VLT Midi Drive FC 280
Category	DC Drives
Language	English