Chapter 3: Installation 35
Login and Configuration
eth1 yes yes (dhcp-supplied) (dhcp-supplied)
eth2 no n/a n/a n/a
*** eth3 yes yes (dhcp-supplied) (dhcp-supplied)
----- ---- ------- ---- --------------- --------------
*** No connection on indicated Ethernet port
Do you want to save these settings (Save|Abort|Retry):
Note An information box also appears in the recap if any interface is set up to use DHCP, but does
not have a live Ethernet connection. After troubleshooting and completing the Ethernet
connection, wait for up to two minutes for the restorer to update the interface. The
Cable
column of the
net show hardware command displays whether or not the Ethernet
connection is live for each interface.
6. The third section is for CIFS (Common Internet File System) configuration and appears only if
the restorer has a CIFS license. At the first prompt, enter yes to configure CIFS parameters.
The default authentication mode is Active Directory.
Note When configuring a replica restorer as part of a Replicator pair, configure the authentication
mode, WINS server (if needed) and other entries as with the originator in the pair. The
exceptions are that a replica does not need a backup user and will probably have a different
backup server list (all machines that can access data that is on the replica).
CIFS Configuration
Configure CIFS at this time (yes|no) [no]: yes
a. Select a user-authentication method for the CIFS user accounts that connect to the
/backup and /ddvar shares on the restorer.
CIFS Authentication
Which authentication method will this system use
(Workgroup|Domain|Active-Directory) [Active Direcctory]:
The Workgroup method has the following prompts. Enter a workgroup, the name of a
CIFS backup account and password, a WINS server name, and backup server names.
Workgroup Name
Enter the workgroup name for this system
[ ]:
Do you want to add a backup user yes|no) [no]:
Backup User
Enter backup user name:
Backup User Password
Enter backup user password:
To Next Page
Loading...