28 Installation
4. Set the static IP address, subnet mask, and gateway address.
a. Press E
NTER to enter the Static IP menu. IP Address
displays on line 2.
b. Press E
NTER to set the static IP address.
The IP address has four sections, separated by periods. A
cursor appears under the digit that will change.
i. Use the arrow keys to change one digit at a time.
ii. The address section shows three digits when it can
be changed and the cursor is under the right-most
digit. Press E
NTER to navigate to the next section of
the address.
iii. When all four sections are correct, press E
NTER.
Subnet Mask displays on line 2 of the LCD panel.
c. Repeat steps i through iii to enter the subnet mask
and gateway address.
5. Press E
NTER when you finish entering all the required
address information. Apply displays on line 2.
6. Press E
NTER to apply your changes.
7. Press the down arrow key to scroll to Exit on line 2.
8. Press E
NTER. Then, press the USER button to return the printer to Ready. The USER button
glows green.
To Next Page
Loading...
