68 Printer Manager
Change settings as needed, and then click Set Current to apply changes.
DebowDelay—Specify the amount of time (in milliseconds) to wait before the debow action
takes place if the card also is being impressed. This value is valid only if an impresser is
installed in the laminator. Set this value to 0 if no delay is required.
Exception Card Settings
Use the following settings when an exception job is sent. These may differ from the settings
specified for cards picked from the input hopper. For example, the card material may be different
or you are laminating a preprinted card. You may need to laminate multiple cards to determine
the best settings to use in your environment.
Exception Card Debow Settings:
ExceptionCardDebowDirection—Set the direction of the debow action in the laminator to
return the card to its proper shape after an overlay is applied. A card may become bowed
slightly due to heat from the laminator.
Down—The debow arms in the laminator press down on the card.
Up—The debow arms press up on the card.
ExceptionCardDebowDistanceDown—Set the amount (distance) to move the debow arms
down. The value is in increments of the debow motor. (This value is used when
ExceptionCardDebowDirection is set to Down.)
Increase the value to bend the card down more.
Decrease the value to bend the card down less.
ExceptionCardDebowDistanceUp—Set the amount (distance) to move the debow arms up.
The value is in increments of the debow motor. (This value is used when
ExceptionCardDebowDirection is set to Up.)
Increase the value to bend the card up more.
Decrease the value to bend the card up less.
26) L1CoolingTime 0 0 [0 – 20000]
27) L2CoolingTime 1000 1000 [0 – 20000]
28) RollerTypeInstalledL1 Standard Standard
29) RollerTypeInstalledL2 Standard Standard
30) ScanBarCodeRetries 0 0 [0 – 5]
Description Default Value
Current Value
(unit) Allowed Range
To Next Page
Loading...
Need help?
General
Weight and Dimensions
