5-2 Adjustments
Setting Laminator Values_____________________________________________________________5-30
Laminator Parameter Dependencies______________________________________________5-31
Temperature_____________________________________________________________________5-32
Patch Size _______________________________________________________________________5-32
Foil Advance Offset ______________________________________________________________5-33
Card Registration Offset __________________________________________________________5-34
Debow Enable___________________________________________________________________5-34
Roller Down Distance_____________________________________________________________5-35
Transport Apply Speed ___________________________________________________________5-35
Foil Control 1(Foil Strip Distance)___________________________________________________5-36
Foil Control 2 (Foil Apply Speed Ratio) _____________________________________________5-36
Foil Control 3 (Foil Registration Speed) _____________________________________________5-37
Duplex Handoff Offset____________________________________________________________5-37
Duplex Home Offset______________________________________________________________5-37
Duplex Flipped Offset ____________________________________________________________5-37
Duplex Reject Offset _____________________________________________________________5-38
Duplex Debow Offset_____________________________________________________________5-38
Duplex Horizontal Infeed Offset ___________________________________________________5-38
Duplex Vertical Infeed Offset _____________________________________________________5-38
MFG Card Registration Baseline___________________________________________________5-39
MFG Temperature Baseline _______________________________________________________5-39
MFG Patch Registration Baseline __________________________________________________5-39
Viewing Laminator Sensors and Enabling Heaters ______________________________________5-40
Testing Laminator Motors_____________________________________________________________5-41
Network Option Adjustments ____________________________________________________ 5-42
Software Adjustment Procedures ________________________________________________ 5-46
Saving and Restoring a Printer Configuration __________________________________________5-46
Start Sentinel Position_________________________________________________________________5-49
Card Registration Offset Adjustment __________________________________________________5-50
Ribbon Offset Adjustment ____________________________________________________________5-51
Updating the Printer Firmware ________________________________________________________5-52
Upper Duplex Rotational Adjustment__________________________________________________5-53
Lower Duplex Rotational Adjustment__________________________________________________5-54
To Next Page
Loading...
Need help?
General
