6-128 Removal and Replacement
Lower Foil Drive Assembly
Removal Procedure
1. Turn off the printer and unplug the power cord.
2. Remove the
Main Enclosure (page 6-15).
3. Disconnect the foil advance motor connector from the laminator control
board.
4. Free up the heater wires from the cable guide on the face of the drive
assembly.
5. Press in on the two retaining tabs and pull the assembly away from the
laminator chassis.
Replacement Notes
• The plastic gears are not retained on their shafts. Make sure the gear train is
replaced according to the image below.
• Re-route the wires according to the image above and the Laminator Rear Wire
Routing Diagram.
To Next Page
Loading...
Need help?
General
